Programmable AC Power Source 61600 series - Barletta Apparecchi Scientifici

Logo Barletta
Vai ai contenuti
Programmable AC Power Source
Model 61600 series
logo Chroma
Programmable AC Source - 61607/61608/61609
Programmable AC Source - 61607/61608/61609
Key Features:

      • Single-phase or three-phase output selectable
      • Programmable slew rate setting for changing voltage and frequency
      • Programmable voltage and current limit
      • AC+DC output mode for voltage DC offset simulation
      • Comprehensive measurement capability
      • One-key recall for different voltage and frequency setting
      • High output current crest factor, ideal for inrush current testing
      • Built-in PFC, provide input power factor over 0.98 (full load)
      • Analog input for power amplifier
      • Turn on, turn off phase angle control
      • Remote control by GPIB, RS232, USB and Ethernet interface
                        61601/ 61602/ 61603/ 61604/ 61605
                        61607/ 61608/ 61609
                        61611/ 61612
                        Power Rating
                        500VA/ 1kVA/ 1.5kVA/ 2kVA/ 4kVA
                        3kVA/ 4.5kVA/ 6kVA
                        12kVA/ 18kVA
                        Output Phase
                        1 Phase
                        1 Phase or 3 Phase
                        1 Phase or 3 Phase
                        Voltage Range
                        0~150V/ 0~300V/ Auto
                        0~175V/ 0~350V/ Auto
                        0~150V/ 0~300V/ Auto
                        DC. 15Hz~1kHz
                        DC. 15Hz~2kHz
                        DC. 15Hz~1.5kHz
                        Parallel Capability
                        Not Available
                        2 units (Max 12kVA)
                        5 units (Max 90kVA)
                        Click to view in PDF format (868 KB)
                        Click to view in PDF format (1352KB)
                        Click to view in PDF format (987 KB)
                        Chroma AC Power Source 61600 series is a production grade AC/DC power source able to deliver precise, pure AC/DC waveforms by easily programming steps.

                        For function, the 61600 series generates a very clean AC output with typical distortion less than 0.3% at full load (50/60Hz, linear load). With the built-in power factor correction circuit (PFC), the 61600 series yields higher efficiency and delivers more output power. The power factor of its input can reach above 0.98 with full load.

                        Using advanced DSP technology, the 61600 series offers precision and high speed measurements such as RMS voltage, RMS current, true power, power factor, and current crest factor. Using the state-of-the-art PWM technology, it’s capable of delivering up to 4~6 times of peak current verses to its maximum rated current. Units also provide an external analog input to amplify the analog signal from arbitrary signal generator.

                        For high power applications, the 61600 series provides a (Master-Slave) parallel operation function, which enables the user to increase AC power output (maximum 90kVA) by connecting AC sources in parallel.The self-diagnosis routine and the full protections against OPP, OCP, OVP and OTP ensure the quality and reliability even in the most demanding engineering and ATE applications.

                        COMPREHENSIVE MEASUREMENTS
                        Chroma AC Power Source 61600 series have built-in 16-bit measurement circuits and firmware utilities to measure the true RMS voltage, current, true power, apparent power, reactive power, power factor, current crest factor, repetitive peak current, and inrush current. Using advanced DSP technology, the 61600 series can measure THD and many orders of current harmonics. The LCD panel can also display voltage and current measurement waveforms via the Waveform Viewer function.
                        Chroma 61600 series allow users to set the slew rate of voltage and frequency. The program will follow the slew rate used to reach the final setting when the output voltage or frequency is changed. This function helps users verify the operating range of input power. For example, users can sweep frequency from 47Hz to 63Hz; or sweep voltage gradually from 90V to 264V instead of only measuring in steps such as 90V, 115V, 230V, and 264V. Additionally, in order to reduce the inrush current during motor startup or UUT power-up, users can decrease the slew rate setting to minimize peak current demands.
                        Model 61607/61608/61609 and 61611/61612 AC sources are capable of delivering single or three-phase output depending on the application. Users can select these output modes easily through the front panel or by remote control. All models are able to provide full power output without derating even in single phase output configuration.
                        Model 61601/61602/61603/61604/61605 AC source provide a 3-PHASE mode by connecting 3 units for 3-phase output application. The master unit will keep Fixed Mode on and send a signal for synchronizing slave units.
                        Chroma 61600 series programmable AC source can provide more power by using the (Master/Slave) parallel output function. While model 61601/61602/61603/61604/61605 does not provide this function, model 61607/61608/61609 is able to connect up to 2 units of the same model series (61507/61508/61509/61607/61608/61609) in parallel configuration. For example: connection of two 61609 6kVA units will achieve total output power of 12kVA; or connecting one 61509 6kVA with one 61607 3kVA unit will achieve total output power of 9kVA.
                        For even higher power, model 61611/61612 is able to parallel up to 5 AC sources of the same model series (61511/61512/61611/61612) either together or with Chroma 18kVA power stage units (A615103). For example: connection of two 61611 12kVA units will achieve total output power of 24kVA; or connecting one 61612 18kVA with two A615103 18kVA units will achieve total output power of 54kVA.
                        Chroma's Softpanel is a graphical user interface that provides extraordinary capabilities and convenience by delivering control of the unit remotely. The 61600 series Softpanel is designed to offer users control of the AC source by applying user friendly interfaces configured in graphical, instrument like settings.

                        This interface also provides Auto Run function with 100 sets voltage / frequency change for multiple loop tests (time scale by seconds). It can also adjust settings like Loop and Count for repeated long-term testing.
                        Another useful function is the Report Generator that automatically records user selected parameters, sampling rates and recording times.
                          Programmable AC power source 0-300V/15-1KHz/500VA, 1ø
                          Programmable AC power source 0-300V/15-1KHz/1kVA, 1ø
                          Programmable AC power source 0-300V/15-1KHz/1.5kVA, 1ø
                          Programmable AC power source 0-300V/15-1KHz/2kVA, 1ø
                          Programmable AC power source 0-300V/15-1KHz/4kVA, 1ø
                          Programmable AC power source 0-350V/15-2KHz/3kVA, 1ø or 3ø
                          Programmable AC power source 0-350V/15-2KHz/4.5kVA, 1ø or 3ø
                          Programmable AC power source 0-350V/15-2KHz/6kVA, 1ø or 3ø
                          Programmable AC power source 0~300V/15~1.5kHz / 12kVA, 1ø or 3ø
                          Programmable AC power source 0~300V/15~1.5kHz / 18kVA, 1ø or 3ø
                          Remote Interface for 61601~61605 (external V input, RS-232 and GPIB interface)
                          Remote interface board (LAN and USB) for 61500/61600/61700 series
                          AC voltage transform unit for 61500/61600 series
                          Soft panel for 61500/61600 series
                          DC noise filter (Max. 16A) for 61500/61600 series
                          Parallelable power stage unit 18KVA (1ø/3ø) for 61511/61512/61611/61612 model
                          Input / Output terminals for parallel connecting (2 units) for 61511/61512/61611/61612/A615103 model
                          Input / Output terminals for parallel connecting (3 units) for 61511/61512/61611/61612/A615103 model
                          Reverse current protection unit for 61511/61512/61611/61612 model
                        Divisioni della società

                        ©1999-2020 - Barletta Apparecchi Scientifici Srl
                        Via Prestinari 2 - 20158 Milano Italy  -  p.IVA 09890900153
                        All rights reserved
                        All trademarks are owned by the respective companies

                        Torna ai contenuti